In the application of high-pressure homogenizer, if the homogenization compliance in front of the high-pressure homogenizer is too low, there are foreign matters in the homogenization material, improper feed diffusion, etc., the equipment may be overloaded. What is the harm of overload? Harm of overload of high-pressure homogenizer: when an extra load is applied to the high-pressure homogenizer, the stress of relevant working parts can surpass their acceptance ability, and it is easy to form loss. Increase additional power consumption and operation cost.

Once the maintenance needs to be stopped, many important parts have been damaged, and there may be expensive maintenance service prices. If the pressure gauge of the high-pressure homogenizer has the above problems again, we can try to find the reason first, and finally find the maintenance personnel to stop the maintenance. Although we can't eliminate the occurrence of these problems, we can prevent similar problems from happening again, deal with and prevent common problems, and make full use of products to make the effect more obvious.
 The high-pressure homogenizer uses the high-pressure reciprocating pump as the power transmission and material escort mechanism to escort the materials to the part of the working valve (primary homogenization valve and secondary emulsification valve). In the process of passing through the working valve, the materials to be disposed will produce intense shear, impact and cavitation under high pressure, so that the liquid substances or solid particles with liquid as the carrier can be ultra-fine.